KAK REM 700 6.5 INCH 350 LEGEND HEAVY PROFILE

KAK INDUSTRY 350 LEGEND  BARREL FOR REMINGTON 700

USES THE SAVAGE "STYLE" BARREL NUT SYSTEM

INCLUDES BARREL AND LOCK NUT

 6.5  INCH HEAVY CONTOUR

350 LEGEND CHAMBER

416R STAINLESS STEEL

MUZZLE THREADED 5/8-24

GREY BLASTED FINISH 

GRADUATED MARKS ON THE BARREL SHANK ALLOW FOR PRECISE HEADSPACE ADJUSTMENTS IN .0017 INCREMENTS

MADE FROM KAK PRODUCED BLANKS IN-HOUSE

SOME INLETTING MAY BE REQUIRED AROUND THE BARREL NUT AND CONTOUR DEPENDING ON YOUR STOCK

PLEASE CONSULT A QUALIFIED GUNSMITH WHEN INSTALLING

THESE BARRELS ARE FOR REMINGTON BOLT ACTIONS (MDL700, MDL7, ETC) HOWEVER THEY USE A SAVAGE "STYLE" BARREL NUT SYSTEM FOR EASE OF INSTALLATION.  

THE BARREL AND LOCK NUT ARE INCLUDED IN THE PACKAGE

INSTALL INSTRUCTIONS

MAKE SURE ALL MATING SURFACES ARE CLEAN ON ACTION FACE, RECOIL LUG, AND LOCK NUT

LIGHTLY GREASE ALL MATING SURFACES

REMOVE EJECTOR FROM BOLT FACE

INSTALL BOLT INTO ACTION

INSTALL GO GAUGE OR KNOWN GOOD CARTRIDGE IN BOLT FACE

REMOVE THE LOCK NUT FROM THE BARREL AND APPLY A SMALL DROP OF BLUE NON PERMANENT LOC-TITE TO THREADS

HAND TIGHTEN LOCK NUT ONTO BARREL TILL IT STOPS AND SLIDE RECOIL LUG ONTO BARREL

TIGHTEN BARREL INTO ACTION GUIDING THE HEADSPACE GAUGE INTO THE CHAMBER

WHEN THE BARREL IS SCREWED IN TILL THE POINT THAT IT IS HITTING ON THE GAGE - THIS IS MINIMUM HEADSPACE

THE GRADUATED MARKS ON THE BARREL SHANK REPRESENT .0017 OF HEADSPACE ADJUSTMENT PER LINE

BACK THE BARREL OFF APPROX ONE GRADUATED LINE TO GIVE PROPER CLEARANCE FOR HEADSPACE

MORE OR LESS HEADSPACE ADJUSTMENT MAY BE REQUIRED DEPENDING ON YOUR APPLICATION

TIGHTEN DOWN LOCK NUT WITH A FACTORY SAVAGE BARREL NUT WRENCH MAKING SURE THAT RECOIL LUG IS ALIGNED PROPERLY WITH AN ALIGNMENT TOOL OR SIMILAR

THE NUT SHOULD BE TORQUED TO A MINIMUM OF 50 FOOT POUNDS

TEST THE FIT OF BOTH GO AND NO-GAGES IN THE CHAMBER TO ASSURE PROPER HEADSPACE HAS BEEN SET