KAK BOLT CATCH ROLL PIN STARTER PUNCH
ALSO KNOWN AS WALT'S TOOL...
DO YOU LACK 6 FINGERS AND AN EXTRA HAND WHEN TRYING TO GET THE BOLT CATCH ROLL PIN STARTED ON YOUR BUILD
THIS 304 STAINLESS TOOL IS A LIKE A SURGEON'S INSTRUMENT, BUT DESIGNED FOR A CAVEMAN
SIZED TO HOLD THE BOLT CATCH ROLL PIN STEADY AND GET IT STARTED WITH OUT SCRATCHING UP YOUR LOWER
WE USED DURABLE RUST FREE 304 STAINLESS BUT KEPT THE DESIGN SIMPLE AND TO THE PRICE POINT LOW
ALL ROLL PINS ARE DIFFERENT BEFORE COMPRESSING, IF THEY ARE A LITTLE LOOSE IN THE TOOL USE A DAB OF GREASE IN THE POCKET TO HOLD IT TIGHT, IF IT'S A LITTLE TIGHT, DON'T WORRY, THE HOLE IN THE LOWER IS TIGHTER.. IT WILL RELEASE ONCE STARTED IN THE LOWER..
ONCE THE PIN IS STARTED USE YOUR NORMAL PUNCH TO DRIVE IT HOME AND GET THAT BUILD OUT TO THE RANGE AND BROKEN IN!!
OTHER ALTERNATIVE USES INCLUDE - CHOPSTICKS, SELF DEFENSE, OR MINE PROBING..
- Tags:
- Category:
Reviews
-
Great tool.
Very smart design. Best way to start bolt catch roll pin, no doubt about it.
-
Finally!!!
It’s a tool I’ve been wanting along time but didn’t think about it until I was working on a new build.
-
Awesome
Best of the best.
-
Awesome
Where has this been my whole life
-
Thanks Walt !!!
After 30 years of working on the AR platform, I have a system worked out with a piece of drill rod as a slave pin and a chopstick. But I decided to treat myself to a nice little addition to the toolbox. I suppose I could have turned myself one of these on the lathe years ago but I never thought of it. Thanks Walt !!!
-
Greatly simplifies the process
This works better than described.. You can install that roll pin in just seconds.. What a handy tool..
-
Yes, yes you do...
Don't you dare scratch another receiver! This is the tool you need. Just get it already, ya cheap skate...
-
Fantastic tool!!! Must have!
Been doing "It" the hard way for so many years... This makes it fast & easy, use this then a pin punch and your done in a few whacks! Still need to tape up the area before use [i advise], but not as much as usual. Only negative thing I have with this tool is the metal is a little soft, but that MAY just be me whacking too hard still... You be the judge! Buy now!
-
A must have
This tool is a MUST for every gunsmith! They are they only company that make one of these that's long like this. the added length makes for an exceptionally easy installation.