40MM Windscreen
$1.50
KAK 40MM M212 Reloadable Casing - OD GREEN - SINGLE
$30.00
This listing is for a single casing
This is a REUSEABLE machined aluminum replacement for the standard nylon M212 plastic casing
These are reloadable / reusable and use our lift charges or standard version lift charges. (38S&W type)
Designed to work with zinc pushers/ M781 projectiles.
Sealant is recommended to keep the m781 projectile seated properly.
The internal volume of our design matches M212 plastic casings so velocities and trajectories are consistant
Machined in house and tested for many uses
loading procedure -
put a SMALL amount of sealer on the zinc pusher base diameter
insert zinc pusher / chalk projectile in M212 casing and twist to distribute sealer
recommended sealer sets up in about 10 min
after your casing becomes used several times and dirty, sealer may not be required to hold the pusher in the case
when at your shooting location and ready to fire, insert blank lift charge in base, should be a tight slip fit. sealer is normally not required for the lift charge
after firing, to decap the casing for reuse position case over a hole on table or on top of another casing and drive out spent lift charge with a 1/4 inch punch or similar
casings can be cleaned if needed with normal methods, but is normally not required
do not seat the lift charge before sealing the pusher and letting is setup
Related Products
-
-
Zinc Pusher for 40MM
$4.06 -
-
Reviews
-
Fantastic Casings
These M212 cases are beautifully machined and finished.