KAK INDUSTRY 7.62x39 COMPLETE BOLT HEAD ONLY
Machined in house and assembled using only the finest steels and components.
KAK Industry takes pride in producing some of the finest bolts available, made 100% in house at our MO facility using the latest in robotics manufacturing tech
Machined from aircraft/bearing quality 9310 steel, heat treated properly, precision ground, and Nitride finished, MPI Tested and marked
Extractor- Enhanced Billet, Phosphate finished
Bolt design used standard length AR15 Firing Pin for proper protrusion
Standard .125 bolt face depth
7.62x39, 9x39, and Similar
** THE EXTRACTOR IS CONSIDERED A WEAR ITEM AND IS NOT COVERED AFTER SHOOTING. **
Excellent bolt, eats brass and steel no problem. Going to get a couple more.
Struggled to find a full x39 BCG. LGS told me I could just use a x39 bolt and put it on my 5.56 carrier. Luckily I found this one in stock. Fit in perfectly with my Franklin armory BC. Bought an enhanced firing pin. Had zero issues so far. Spits out steel ammo flawlessly.
a most excellent product nary a misfire or failure to extract. beautifully machined and finished plus super fast service. thank you!
never have had a misfire , light primer strike or failure to feed or extract. maybe a little pricey but well worth the money. it eats tula! if you want your 7.62x39 to work every time get one!
I have several AR pistols in 7.62x39mm, I actually prefer it to the 300 Blackout. These KAK bolts ans BCG's are top notch. these are ready to run, and will light steel case ammo every time (unless the primers are bad). These are well worth the money !!!