SPECIAL EXTENDED AR-15 / LR-308 MAGAZINE RELEASE

I have a DPMS 308 lower. Standard ar mag release arm barely caught the mag button. This arm worked great and fully threaded into the mag button. Price was acceptable and shipping was extremely fast. Will order again when needed. Thanks

Didn’t realize my receiver was wider than most but once I did, thought I was phooked...but thanks to the KAK Extended AR15/LR308 Magazine Release I was back in the build! It’s a perfect fit, easy transaction and most of all my .308 is done! Thanks guys!!

Building a LR308 sure provides a lot of lessons. Since there is no "Mil-Spec" for 308 lowers the builds can be challenging to us first timers! Until I found these extended magazine release arms I didn't feel comfortable firing my rifle due to the very poor engagement and floppy nature of the magazine release, it just didn't feel "right". This extended arm fixed the issue and for only a few dollars and worked well with my extended release button!

Could find the proper bolt extended release arm for my LR-308 build until I found these. Makes up for the need to purchase "extended buttons" - though this arm will work with them as well! Gives that extra 3/16 of an inch that is needed to flush out the release bolt to the top of the release button. A must "BUY" for your 308 builds.

Filled in the open space the factory aero m5 LPK leaves

Fit perfectly. Put the standard mag button right where it needed to be with full thread engagement. I also added an extended button just to make the release even easier. This should be a standard part in every AR10 lower parts kit.

I am Building an LR308 and the lower kit I purchased from a different company the Mag release was not long enough to properly thread the push button on. With this extended release it was long enough so now I will not worry about it stripping and comming off .Thank You.

I ordered this extended magazine release for my new AR10 build after discovering that the original one in my parts kit was not long enough to properly thread on the mag release button. The fit on the KAK part was perfect, the price was good and the shipping was fast. I am most pleased and will look to them again.

Item is perfect for finishing any billet lower or LR308 that needs the extra length mag release, couple this with an extended mag button and it will fit any lower out there.