MICRO LENGTH GAS TUBE Gas tube Micro by KAK Industry LLC Visit kakindustry.com

MICRO LENGTH GAS TUBE

SKU:
MICRO-LENGTH-GAS-TUBE
$18.00
(21 reviews)
Current Stock:
Adding to cart… The item has been added
Description
MICRO LENGTH GAS TUBE
THIS GAS TUBE IS 1.5 INCHES SHORTER THAN A PISTOL GAS TUBE
FOR CUSTOM AND SPECIAL PURPOSE BUILDS
Additional Information
Tags:
Category:
AR-15 Parts, Gas System

Reviews

  • 4
    MICRO-LENGTH-GAS-TUBE

    Posted by Menger on June 18, 2019

    Kakindustry has at least the best multiple gas tubes on their website or anywhere. Having say this mirco gas tube... at least can't be found because these type of build is kinda rare and not a lot of company support or isn't willing to take the extra steps like Kakindustry. Again having said not only they carry this mirco gas tube they even have the longer version than the rifle gas tube. All and all this statement isn't really about the mirco gas tube but from the looks of it I believe that the mirco gas tube should of come with one roll pin. I received the gas tube 6/17/19 and the mirco gas tube is bag inside greatly however the only issues as stated is No roll pin to pin with the gas block. By this you and I are going to spend another .2 cent on getting a new roll pin but if you have spare parts or so, then it's not going to be a issue. Since most can't wait on another ordered because it supposed to come with not without one and this is the only downside of this mirco gas tube.

  • 5
    Great gas tube. Bet needs to get bent...

    Posted by Wilford on June 16, 2019

    This gas tube was almost perfect. Married this with the 4.75 inch KAK barrel and a 5.5 inch hand guard and the KAK Micro Flash Can. The bends in the gas tube were very tight creating forward pressure on the gas block. But the overall look turned out great. The Micro Flash Can stick out 1/4 of an inch past the 5.5 in handguard. The tub and block required a tad bit of adjustment.

  • 5
    Works only with 4.75" barrel

    Posted by Donald on February 4, 2019

    Works great with your 4.75" barrel but should bend up closer to the gas block. This would allow use of more barrel nuts from different vendors.